L2Tp Unlock Destination - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

l2tp unlock destination

l2tp unlock destination { destinationName | [ virtual-router vrName ] ip ipAddress }
Syntax
Command introduced in JUNOSe Release 7.2.0.
Release Information
Forces L2TP to immediately unlock the specified L2TP destination and return the
Description
destination to the available state. Any remaining lockout time and the lockout test
setting (if configured) are not taken into account. There is no no version.
Options
Privileged Exec (at privilege level 10 or higher)
Mode
destinationName Name of the L2TP destination
vrName Name of the virtual router on which the destination exists
ipAddress IP address of the destination
Chapter 12: L Commands
l2tp unlock destination
1197