Ip Inactivity-Timer - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

ip inactivity-timer

[ no ] ip inactivity-timer inactiveTime
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
Configures an inactivity timer. IP polls the dynamic interface at the configured interval
Description
to determine whether the interface was active during the interval. Inactive interfaces
are deleted only when the period of inactivity is equal to or greater than the configured
value. The no version disables the timer.
Options
Interface Configuration, Profile Configuration
Mode
842
ip inactivity-timer
inactiveTime Length of time in the range 0–63335 minutes; a value of 0 specifies
that dynamically created subscriber interfaces are not deleted