Flash-Disk Initialize - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

flash-disk initialize

flash-disk initialize [ no-format ] [ disk0 | disk1 ]
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
disk0 and disk1 keywords added in JUNOSe Release 7.2.0.
Privileged Exec mode added in JUNOSe Release 8.0.0.
Performs a low-level format of unmounted flash cards. There is no no version.
Description
Options
Boot, Privileged Exec
Mode
no-format Erases all files but does not format the flash card
disk0 Specifies flash card in slot 0 of the SRP module; default value is disk0;
available only in Boot mode, because disk0 cannot be in an unmounted state in
a router outside of Boot mode
disk1 Specifies flash card in slot 1 of the SRP module; supported only on the
E120 router and the E320 router
Chapter 7: F Commands
633
flash-disk initialize