Ip Vrrp Icr-Partition - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

ip vrrp icr-partition

[ no ] ip vrrp vrid icr-partition partitionId
Syntax
Command introduced in JUNOSe Release 10.3.0.
Release Information
Creates an ICR partition that corresponds to the VRRP instance. The state of the ICR
Description
partition depends on the state of the VRRP instance. If the VRRP instance is disabled,
the ICR partition is in the dormant state. If the VRRP instance is enabled, the ICR
partition follows the state of the VRRP instance. The no version deletes the partition
from the router.
Options
NOTE: Use the ICR-Partition-Id VSA to determine the ICR partition on which
subscribers are logged in. You can configure the same ICR-Partition-Id string for an
active ICR partition and its corresponding backup partition. For more information
on ICR-PArtition-ID VSA, see Interaction with RADIUS for ICR.
Interface Configuration, Subinterface Configuration
Mode
Related Topics
978
ip vrrp icr-partition
vrid VRID identifier; a number in the range 1–255
partitionId Name that identifies the ICR partition; a string of up to 128
alphanumeric characters
Naming ICR Partitions
Configuring an ICR Partition