Equipment Loopback - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

equipment loopback

equipment { customer | network } loopback
Syntax
no equipment
Command introduced before JUNOSe Release 7.1.0.
Release Information
Enables or disables the router's ability to be placed in loopback by a remote device
Description
connected on a CT3 or T3 interface. The no version disables the router's ability to
be placed in loopback by the remote device.
Options
Controller Configuration
Mode
customer Enables the router to enter into loopback when it receives an
appropriate signal from the remote interface
network Disables the router's ability to enter into loopback when it receives
an appropriate signal from the remote interface
Chapter 6: E Commands
577
equipment loopback