Mdl Transmit - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

mdl transmit

[ no ] mdl transmit { path-id | idle-signal | test signal }
Syntax
no mdl transmit
Command introduced before JUNOSe Release 7.1.0.
Release Information
Transmits an MDL message from a T3 interface. The no version disables transmission
Description
of the specified MDL message or all MDL messages.
Options
Controller Configuration
Mode
path-id Transmits a path identification message every second; default value is
disabled
idle-signal Transmits an idle signal message every second; default value is
disabled
test-signal Transmits a test signal message every second; default value is
disabled
Chapter 13: M Commands
1305
mdl transmit