Halt - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

halt

The syntax of the command depends on whether you enter it from Boot mode or
Syntax
Privileged Exec mode.
From Boot mode:
halt
From Privileged Exec mode:
halt [ force | primary-srp [ force ] | standby-srp [ force ] ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
Stops operation on both SRP modules or on the specified SRP module. When the
Description
high availability state is active or pending, this command ensures that the router
configuration, up to when you issued the halt command, is mirrored to the standby
SRP module. There is no no version.
CAUTION: To prevent corruption of NVS, issue this command before you remove or
power down an SRP module.
Options
CAUTION: When the high availability state is active or pending, issuing the force
keyword does not guarantee that the configuration has been mirrored; recent
configuration changes may be lost if you issue the force keyword.
Boot, Privileged Exec
Mode
680
halt
force Prompts the user to confirm that the router should stop operation if the
SRP modules are in certain states, such as writing configuration data to NVS,
that could lead to loss of configuration data or corruption of NVS.
primary-srp Stops operation on primary SRP module only
standby-srp Stops operation on standby SRP module only