Ip Pim Spt-Threshold - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

ip pim spt-threshold

[ no ] ip pim spt-threshold { 0 | nonzero_integer | infinity } [ group-list ipAccessList
Syntax
]
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies the network configuration that PIM sparse mode uses when a source starts
Description
sending multicast messages. The no version restores the default value, 0.
Options
Global Configuration
Mode
908
ip pim spt-threshold
0 Configures PIM sparse mode to switch to an SPT when a source begins to
send multicast messages
nonzero_integer—Integer in the range 1–4294967294; prevents PIM sparse mode
from switching from a shared tree to an SPT
infinity—Prevents PIM sparse mode from switching from a shared tree to an
SPT
ipAccessList—Name of the IP access list that specifies the groups to which the
threshold applies