Mpls-Relay Atm Cell-Packing Mcpt-Timer - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

mpls-relay atm cell-packing mcpt-timer

mpls-relay atm cell-packing maxCellsPerPacket mcpt-timer timerIdentifier
Syntax
no mpls-relay atm cell-packing
Command introduced in JUNOSe Release 10.2.0.
Release Information
Configures cell concatenation parameters for an ATM port to calculate the maximum
Description
number of ATM cells that the router can concatenate in a single packet and the unique
identifier of the ATM Martini cell packing timer that you want to use to detect timeout
of the cell collection threshold. You can configure this command on the ATM port
only after you associated a pseudowire with the port by using the mpls-relay or route
interface tunnel command. You can use this command only on an ATM port (ATM
AAL5 over ATM major interface). The no version disables cell concatenation, which
is the default behavior.
Options
Interface Configuration
Mode
Related Topics
1398
mpls-relay atm cell-packing mcpt-timer
atm Configures ATM interface parameters for MPLS cross-connect
maxCellsPerPacket Maximum number of ATM cells in the range 1–190 that the
router can concatenate in a single VCC cell relay-encapsulated packet and transmit
on an MPLS pseudowire connection; default value is 1 cell per packet
timerIdentifier Integer in the range 1–3 that identifies which of the three ATM
Martini cell packing timers (timer 1, timer 2, or timer 3) you want to use to detect
timeout of the cell collection time threshold; default value is 1. When the timer
expires, the router forwards the packet even if the number of concatenated ATM
cells in the packet is fewer than the specified maximum number of cells per
packet.
Multiple ATM Virtual Circuits over a Single Pseudowire Overview and Multiple ATM
Virtual Circuits over a Single Pseudowire Example in the JUNOSe BGP and MPLS
Configuration Guide