Chapter 10: I Commands
inarp
inarp [ frequency ]
Syntax
no inarp
Command introduced in JUNOSe Release 7.1.0.
Release Information
ATM VC Class Configuration mode added in JUNOSe Release 7.3.0.
In ATM VC Configuration mode, enables Inverse ARP (InARP) on an ATM PVC that
Description
resides on an ATM 1483 NBMA subinterface. Optionally, you can specify the InARP
refresh rate. The inarp command is valid only for data PVCs configured with aal5snap
encapsulation; you cannot use this command for data PVCs with other encapsulation
types or for control (ILMI or signaling) PVCs. The no version restores the default
behavior, which disables InARP.
In ATM VC Class Configuration mode, enables InARP as part of a VC class definition
that you assign to an ATM data PVC. The no version restores the default behavior,
which disables InARP, in the VC class.
frequency InARP refresh rate in minutes, in the range 1–60; default value is 15
Options
ATM VC Configuration, ATM VC Class Configuration
Mode
709
inarp