Frame-Relay Lmi-N391Dte - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

frame-relay lmi-n391dte

frame-relay lmi-n391dte keepExchanges
Syntax
no frame-relay lmi-n391dte
Command introduced before JUNOSe Release 7.1.0.
Release Information
Sets the full-status polling counter (N391) on a DTE interface. The no version restores
Description
the default value, assuming an LMI has been configured.
Options
Interface Configuration
Mode
648
frame-relay lmi-n391dte
keepExchanges—Number in the range 1– 255; default value is 6; number of keep
exchanges to be done before requesting a full-status message. If you specify a
value of 1, you receive full-status messages only.