Debug Ip Ospf - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

debug ip ospf

debug ip ospf ospfLog [ severity { severityValue | severityNumber } ]
Syntax
[ verbosity verbosityLevel ]
no debug ip ospf ospfLog
Command introduced before JUNOSe Release 7.1.0.
Release Information
Shows information about the selected variable. The no version disables the display.
Description
Options
486
debug ip ospf
ospfLog OSPF log of interest; one of the following options:
adj OSPF adjacency events
elect-dr OSPF designated router election
events OSPF general events
lsa OSPF link-state advertisements events
neighbor OSPF neighbor state machine
packets-rcvd OSPF packets received
packets-sent OSPF packets sent
route OSPF route events
spf All OSPF shortest path first calculation events
spf-ext OSPF shortest path first external route calculation events
spf-inter OSPF shortest path first interarea route calculation events
spf-intra OSPF shortest path first intra-area route calculation events
severity Specifies the minimum severity of the log messages displayed for the
selected category; described either by a descriptive term severityValue or by
a corresponding number severityNumber in the range 0–7; the lower the
number, the higher the priority:
emergency or 0 System unusable
alert or 1 Immediate action needed
critical or 2 Critical condition exists
error or 3 Error condition
warning or 4 Warning condition
notice or 5 Normal but significant condition