Ip Auto-Configure Ip-Subscriber - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

ip auto-configure ip-subscriber

[ no ] ip auto-configure ip-subscriber [ include-primary | exclude-primary ]
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
include-primary and exclude-primary keywords added in JUNOSe Release 7.1.0.
Configures a primary IP interface to support creation of dynamic subscriber interfaces.
Description
The include-primary and exclude-primary keywords specify whether the primary
interface can be assigned to a subscriber. The no version disables creation of dynamic
subscriber interfaces on this primary IP interface.
Options
Interface Configuration, Profile Configuration, Subinterface Configuration
Mode
748
ip auto-configure ip-subscriber
include-primary Specifies that the primary interface can be assigned to a
subscriber; the no version disables the assignment of the primary interface
exclude-primary Specifies that the primary interface cannot be assigned to a
subscriber; the no version enables the assignment of the primary interface