L2Tp Shutdown Destination - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

l2tp shutdown destination

[ no ] l2tp shutdown destination { destinationName |
Syntax
[ virtual-router vrName ] ip ipAddress }
Command introduced before JUNOSe Release 7.1.0.
Release Information
Closes all tunnels and sessions at a destination, and prevents the creation of new
Description
tunnels and sessions at that destination. This command works in conjunction with
the l2tp drain destination command. Both commands affect the status of the
administrative state of L2TP on the destination; the l2tp shutdown destination
command sets the administrative state to disabled. The no version enables the
creation of new tunnels and sessions at that destination.
Options
Global Configuration
Mode
1188
l2tp shutdown destination
destinationName Name the router assigns to the LNS
vrName—Name of the virtual router on which the destination exists
ipAddress IP address of the LNS