Ipv6 Address-Pool Local - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

Chapter 10: I Commands

ipv6 address-pool local

[ no ] ipv6 address-pool local
Syntax
Command introduced in JUNOSe Release 10.1.0.
Release Information
Enables the IPv6 local address pool functionality to allow configuration of IPv6 local
Description
address pools to assign prefixes to DHCPv6 clients. The no version disables the IPv6
local address functionality.
NOTE: If you attempt to configure an IPv6 local address pool without enabling the
IPv6 local pool feature, an error message is displayed.
Global Configuration
Mode
1017
ipv6 address-pool local