Ipv6 Classifier-List - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

For e series broadband services routers - command reference a to m
Table of Contents

Advertisement

ipv6 classifier-list

ipv6 classifier-list classifierName [ traffic-class trafficClassName ]
Syntax
[ color { green | yellow | red } ] [ user-packet-class userPacketClassValue ]
[ source-route-class routeClassValue ] [ destination-route-class routeClassValue ]
[ local { true | false } ]
[ source-address ipv6Prefix | source-host ipv6Address ]
[ destination-address ipv6Prefix | destination-host ipv6Address ]
[ precedence precNum | dsfield dsFieldNum | tcfield tcFieldNum ]
[ protocol [ protocolQualifier ] ]
no ipv6 classifier-list classifierName [ classifierNumber ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
Creates or modifies an IPv6 classifier control list. The no version removes the classifier
Description
control list.
Options
classifierName Name of the classifier control list entry
trafficClassName Name of the traffic class to match
green Matches packet color to green, indicating a low drop preference
yellow Matches packet color to yellow, indicating a medium drop preference
red Matches packet color to red, indicating a high drop preference
userPacketClassValue User packet value to match
routeClassValue Value of the source or destination route-class; in the range
0–255
local Specifies traffic destined for this interface
true Matches packets that are locally destined
false Matches packets that are not locally destined
ipv6Prefix Prefix that defines the IPv6 interface or network
ipv6Address Base IPv6 address of the network route
precNum Upper three bits of the traffic class byte; in the range 0–7
dsFieldNum Upper six bits of the traffic class byte; in the range 0–63
tcFieldNum Whole eight bits of the traffic class byte; in the range 0–255
protocol Protocol type to match; tcp, udp, icmpv6, or protocol number in the
range 0–255
protocolQualifier—Specifies the following protocol-specific parameters:
For TCP and UDP:
source-port or destination-port Specifies that a source or destination port
is matched
Chapter 10: I Commands
1019
ipv6 classifier-list

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.1.x

Table of Contents