Ip Pim Join-Prune-Interval - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

ip pim join-prune-interval

ip pim join-prune-interval interval
Syntax
no ip pim join-prune-interval
Command introduced in JUNOSe Release 10.0.0.
Release Information
Specifies the time interval at which the router sends the PIM join/prune message to
Description
the upstream RPF neighbor. In Interface Configuration mode, the no version restores
the value that is specified in Router Configuration mode. If the message interval is
not specified in Router Configuration mode, then the default value of 60 seconds is
restored.
NOTE: You cannot configure the designated router priority on PIM dense mode
interfaces.
Options
Interface Configuration, Router Configuration
Mode
interval Interval in the range 10–210 seconds at which the router sends the
PIM join/prune message; the default value is 60 seconds.
Chapter 10: I Commands
ip pim join-prune-interval
901