Line - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

line

line { console lineNumber | vty lineRangeStart [ lineRangeEnd ] }
Syntax
no line vty lineNumber
Command introduced before JUNOSe Release 7.1.0.
Release Information
Opens virtual terminal lines or the console line and allows you to configure the lines.
Description
By default five vty lines (0–4) are open. The no version removes a vty line or a range
of lines from your configuration; users will not be able to run Telnet, SSH, or FTP to
lines that you remove. When you remove a vty line, the router removes all lines
above that line. For example, no line vty 6 causes the router to remove lines 6
through 29. You cannot remove lines 0 through 4.
NOTE: Once lines are open, login is enabled by default. Before users can access the
lines, you must configure a password, disable login using the no login command,
or configure AAA authentication on the line.
Options
Global Configuration
Mode
console Specifies the console line
vty Specifies vty lines
lineNumber—Number of a single line; 0 for the console line
lineRangeStart Start of the vty line range; a number from 0–29
lineRangeEnd End of the vty line range; a number from 0–29
Chapter 12: L Commands
1223
line