Ipv6 Nd Reachable-Time - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

ipv6 nd reachable-time

ipv6 nd reachable-time { milliseconds | hours minutes seconds }
Syntax
no ipv6 nd reachable-time
Command introduced before JUNOSe Release 7.1.0.
Release Information
Profile Configuration mode added in JUNOSe Release 9.0.0.
Specifies the amount of time that the E Series router can reach a remote IPv6 node
Description
after some reachability confirmation event has occurred. The no version restores
the default value 0 milliseconds for router advertisements and 3,600,000 milliseconds
(1 hour) for Neighbor Discovery activity of the E Series router.
Options
Interface Configuration, Profile Configuration
Mode
milliseconds Amount of time, in the range 0–21600000 milliseconds, that the
E Series router can reach a remote node after some reachability confirmation
event has occurred
hours minutes seconds—Amount of time, in the range 0 hours 0 minutes
0 seconds – 6 hours 0 minutes 0 seconds, that the E Series router can reach a
remote node after some reachability confirmation event has occurred; this
specification is not supported in Profile Configuration mode
Chapter 10: I Commands
ipv6 nd reachable-time
1075