L2Tp Ignore-Receive-Data-Sequencing - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

l2tp ignore-receive-data-sequencing

[ no ] l2tp ignore-receive-data-sequencing
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
Suppresses sequence number checking for data packets received on all L2TP tunnels
Description
in the router. This setting affects only packets received on a tunnel, not packets sent
on a tunnel. The L2TP LAC still inserts sequence numbers into data packets if the
LAC receives packets from the LNS that contain sequence numbers. The no version
restores the default, which causes the router to check the sequence numbers in data
packets that it receives on L2TP tunnels.
NOTE: If you are using IP reassembly, we recommend that you set up the router to
ignore sequence numbers in received data packets. Because IP reassembly may
reorder L2TP packets, out-of-order packets may be dropped if sequence numbers
are being used on L2TP data packets.
Global Configuration
Mode
1178
l2tp ignore-receive-data-sequencing