Forwarding-Table Route-Holddown - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

forwarding-table route-holddown

forwarding-table route-holddown timerValue
Syntax
no forwarding-table route-holddown
Command introduced before JUNOSe Release 7.1.0.
Release Information
Sets the number of seconds allowed after a routing table change for the accumulation
Description
of additional updates and subsequent distribution of the set of routing table changes
to the line modules. The no version sets the hold-down time to the default value (3
seconds).
Options
Global Configuration
Mode
timerValue—Number of seconds allowed for the accumulation and subsequent
distribution of routing table updates to the line modules; a range of 0-30 seconds,
where 0 specifies an update following each routing table change
Chapter 7: F Commands
forwarding-table route-holddown
639