Ip Address - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

ip address

ip address ipAddress ipMask [ secondary ]
Syntax
no ip address [ ipAddress ipMask [ secondary ] ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
Sets a primary or secondary IP address for an interface or subinterface. The no
Description
version removes an IP address or disables IP processing. You must specify the layer
2 encapsulation before you can set the IP address.
Options
Interface Configuration, Profile Configuration, Subinterface Configuration
Mode
Related Topics
738
ip address
ipAddress IP address in 32-bit dotted decimal format (for example, 192.56.32.2)
ipMask—mask for associated IP subnet in dotted decimal or prefix length notation
secondary Specifies that the configured address is a secondary IP address; if
omitted, the configured address is the primary IP address
Configuring Local ATM Cross-Connects with AAL5 Encapsulation, Configuring Local
Cross-Connects Between Ethernet/VLAN Interfaces, Configuring the Loopback
Interface and Router ID for BGP for L2VPNs, Configuring the Loopback Interface
and Router ID for VPLS, and Configuring MPLS LSPs for L2VPNs in the JUNOSe
BGP and MPLS Configuration Guide