Mirror - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

mirror

To mirror a specified trigger type:
Syntax
mirror triggerType [hex] triggerValue { ip | ipv6 | l2tp } secure-policy-list policyName
no mirror triggerType [hex] triggerValue { ip | ipv6 | l2tp }
To mirror the agent-circuit-id or agent-remote-id trigger types, when the hex variant
is used:
mirror triggerType hex triggerValue { ip | ipv6 | l2tp } secure-policy-list policyName
no mirror triggerType hex triggerValue { ip | ipv6 | l2tp }
To mirror the dhcp-option-82 trigger type:
mirror dhcp-option-82 agent-circuit-id triggerValue1 agent-remote-id triggerValue2
ip secure-policy-list policyName
no mirror dhcp-option-82 agent-circuit-id triggerValue1 agent-remote-id triggerValue2
ip
To mirror the dhcp-option-82 trigger type, when the hex variant is used:
mirror dhcp-option-82 hex triggerValue ip secure-policy-list policyName
no mirror dhcp-option-82 hex triggerValue ip
Command introduced before JUNOSe Release 7.1.0.
Release Information
nas-port-id keyword added in JUNOSe Release 7.1.0.
IPv6 support added in JUNOSe Release 10.1.0.
hex keyword added in JUNOSe Release 11.1.0.
Enables packet mirroring based on the specified trigger and specifies the secure
Description
policy to attach to the subscriber's interface. The no version disables packet mirroring
for the subscriber and removes the trigger configuration.
NOTE: The hex variant is applicable only for agent-circuit-id, agent-remote-id, and
dhcp-option-82 trigger types. If the hex variant is used then the triggerValue must be
a hexadecimal number.
Options
1322
mirror
triggerType One of the following RADIUS attributes
acct-session-id Acct-Session-Id, RADIUS attribute [44]
agent-circuit-id Agent Circuit ID, RADIUS attribute [26–1], Vendor ID 3561