Debug Ipv6 Pim - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

debug ipv6 pim

debug ipv6 pim
Syntax
{ pimLog [ severity { severityValue | severityNumber } ] [ verbosity verbosityLevel ] |
switchState groupAddress sourceAddress |
dense-mode { on | off } |
sparse-mode { on | off | sg-state [ group groupAddress
[ source sourceAddress ] | rp rpAddress ] [ count ] } }
no debug ipv6 pim pimLog
Command introduced before JUNOSe Release 7.1.0.
Release Information
Shows information about the selected variable. The no version disables the display.
Description
Options
pimLog PIM log of interest; one of the following options:
autoRp-rcvd Auto-RP packets received
autoRP-sent Auto-RP packets sent
engineering PIM engineering
hellos-rcvd PIM hello messages received
hellos-sent PIM hello messages sent
packets PIM packets received and sent
packets-rcvd PIM packets received
packets-sent PIM packets sent
severity Specifies the minimum severity of the log messages displayed for the
selected category; described either by a descriptive term severityValue or by
a corresponding number severityNumber in the range 0–7; the lower the
number, the higher the priority:
emergency or 0 System unusable
alert or 1 Immediate action needed
critical or 2 Critical condition exists
error or 3 Error condition
warning or 4 Warning condition
notice or 5 Normal but significant condition
info or 6 Informational message
debug or 7 Debug message
Chapter 5: D Commands
493
debug ipv6 pim