Mirror Disable - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

mirror disable

To disable mirroring for a specified trigger type:
Syntax
mirror disable triggerType [hex] triggerValue
To disable mirroring for the agent-circuit-id or agent-remote-id trigger types, when
the hex variant is used:
mirror disable triggerType hex triggerValue
To disable mirroring for the dhcp-option-82 trigger type:
mirror disable dhcp-option-82 agent-circuit-id triggerValue1 agent-remote-id
triggerValue2
To disable mirroring for the dhcp-option-82 trigger type, when the hex variant is
used:
mirror disable dhcp-option-82 hex triggerValue
Command introduced before JUNOSe Release 7.1.0.
Release Information
nas-port-id added in JUNOSe Release 7.1.0.
hex keyword added in JUNOSe Release 11.1.0.
Disables a packet mirroring session that was dynamically configured for a subscriber;
Description
uses the trigger information to identify the subscriber's session. There is no no
version.
NOTE: The hex variant is applicable only for agent-circuit-id, agent-remote-id, and
dhcp-option-82 trigger types. If the hex variant is used then the triggerValue must be
a hexadecimal number.
Options
triggerType One of the following RADIUS attributes that was used as the trigger
to start the packet mirroring session
acct-session-id Acct-Session-Id, RADIUS attribute [44]
agent-circuit-id Agent Circuit ID, RADIUS attribute [26–1], Vendor ID 3561
agent-remote-id Agent Remote ID, RADIUS attribute [26–2], Vendor ID
3561
calling-station-id Calling-Station-Id, RADIUS attribute [31]
dhcp-option-82 DHCP Option 82, RADIUS attribute [26–159], Vendor ID
4874
ip-address Framed-IP-Address, RADIUS attribute [8]; associated with the
virtual router where the command is issued, RADIUS VSA [26-1]
Chapter 13: M Commands
1325
mirror disable