Maximum Routes - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

maximum routes

maximum routes limit { warningThreshold | warning-only }
Syntax
no maximum routes
Command introduced before JUNOSe Release 7.1.0.
Release Information
Sets a warning threshold and maximum limit for routes imported by a PE router into
Description
a VRF from associated CE routers. The no version removes the limit and warning
threshold.
Options
VRF Configuration
Mode
1296
maximum routes
limit—Number in the range 1–4294967295 that when exceeded prevents routes
from being imported into the routing table; when first exceeded generates a
limit-exceeded log entry; if the route count fluctuates below and up to this value,
an interval of five minutes must pass before another limit-exceeded log entry
can be generated
warningThreshold—Percentage in the range 1–100 that when first exceeded
generates a warning-threshold-exceeded log entry; if the route count fluctuates
around this value, an interval of five minutes must pass before another
warning-threshold-exceeded log entry can be generated
warning-only Causes the limit to function as a warningThreshold; specifies that
exceeding the limit generates a warning-threshold-exceeded log entry instead
of a limit-exceeded log entry and permits routes exceeding the limit to be added
to the routing table; if the route count fluctuates around the limit, an interval of
five minutes must pass before another warning-threshold-exceeded log entry
can be generated