Debounce - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

debounce

debounce [ seconds ]
Syntax
no debounce
Command introduced in JUNOSe Release 9.3.0.
Release Information
Enables the debounce timer and sets the time interval that the interface waits before
Description
reporting a state change to the upper-layer protocols. The no version restores the
default behavior, disabling debounce on the interface.
Options
Interface Configuration
Mode
seconds Interval for which an interface must maintain a given state before the
interface reports the state change to the upper-layer protocols. Number in the
range 1–5 seconds; default value is 1 second.
Chapter 5: D Commands
479
debounce