Debug Ip Mbgp - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

debug ip mbgp

debug ip mbgp [ in | out ] [ peerAddress [ peerAddressMask ] ] [ bgpLog ]
Syntax
[ router routerName ] [ filtering-router filteringRouterName ] [ accessClassName ]
[ route-map mapName ] [ severity { severityValue | severityNumber } ]
[ verbosity verbosityLevel ] [ secondary ]
no debug ip mbgp [ in | out ] [ peerAddress [ peerAddressMask ] ] [ bgpLog ]
[ router routerName ] [ filtering-router filteringRouterName ] [ accessClassName ]
[ route-map mapName ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
Shows information about the selected variable. The no version disables the display.
Description
Options
484
debug ip mbgp
in Displays information for inbound events
out Displays information for outbound events
peerAddress IP address of BGP peer for which information is displayed
peerAddressMask Network mask of BGP peer for which information is displayed
bgpLog—BGP log of interest; one of the following options:
dampening BGP dampening event; route is suppressed or no longer
suppressed by route-flap dampening
events BGP finite state machine events and transitions
keepalives BGP keepalive message events
next-hops BGP next hop events
updates BGP routing table update events
routerName—Name of the virtual router that owns the BGP router for which
information is being displayed
filteringRouterName Name of the virtual router that owns the access class and
route map parameters
accessClassName—Name of an access list to filter output
mapName Name of a route map to filter output
severity Specifies the minimum severity of the log messages displayed for the
selected category; described either by a descriptive term severityValue or by
a corresponding number severityNumber in the range 0–7; the lower the
number, the higher the priority:
emergency or 0 System unusable
alert or 1 Immediate action needed
critical or 2 Critical condition exists