Log-Adjacency-Changes - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

log-adjacency-changes

For IS-IS adjacencies:
Syntax
log-adjacency-changes [ severity { severityValue | severityNumber } ]
[ verbosity verbosityLevel ]
no log-adjacency-changes
For OSPFv3 adjacencies:
[ no ] log-adjacency-changes [ severity { severityValue | severityNumber } ]
[ verbosity verbosityLevel ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
Generates a log message when the state of an IS-IS adjacency or an OSPFv3 neighbor
Description
changes. For OSPFv2 neighbors, use the ospf log-adjacency-changes command.
Manipulates the same log as the Global Configuration log commands. The no version
disables this function.
Options
severity Sets minimum severity of the log messages for this category; described
either by a descriptive term severityValue or by a corresponding
number severityNumber in the range 0–7. The lower the number, the higher
the priority:
emergency or 0 System unusable
alert or 1 Immediate action needed
critical or 2 Critical condition exists
error or 3 Error condition
warning or 4 Warning condition
notice or 5 Normal but significant condition
info or 6 Informational message
debug or 7 Debug message
verbosity Specifies the verbosity of this log category's messages
verbosityLevel Specifies the verbosity of the log category's messages; can be
any of the following:
high Verbose
low Terse
medium Moderate detail
Chapter 12: L Commands
1239
log-adjacency-changes