Ip Vrrp Icr-Partition Svlan-List - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

ip vrrp icr-partition svlan-list

ip vrrp vrid icr-partition svlan-list [ svlanIdValue ] *
Syntax
[ use-default-mac ] [ control-interface ] [ advertise-mac ]
no ip vrrp vrid icr-partition svlan-list [ svlanIdValue ] *
Command introduced in JUNOSe Release 10.3.0.
Release Information
Adds an S-VLAN to the ICR partition. You can assign only unique S-VLANs to the
Description
partition. If you attempt to assign a previously assigned S-VLAN to the ICR partition,
the router displays an error message. You can assign S-VLANs only if you have
selected S-VLAN based grouping by using the ip vrrp icr-partition group command.
The no version deletes the S-VLAN from the ICR partition.
NOTE: You can use the listed optional parameters only when you add a S-VLAN to
the ICR partition. You cannot modify an existing subinterface using these parameters.
You can specify the optional parameters in any order.
Options
Interface Configuration, Subinterface Configuration
Mode
Related Topics
980
ip vrrp icr-partition svlan-list
vrid VRID identifier; a number in the range 1–255
svlanIdValue S-VLAN identifier; a number in the range 0–4095
use-default-mac Configures the S-VLAN to use the default MAC address. By
default, the router assigns the VRRP media access control (MAC) address to all
subinterfaces of the ICR partition.
control-interface Controls traffic on a subinterface that is part of a backup
partition. When you use this option, the router changes the state of the
corresponding subinterface to Admindown. When the subinterface is in
Admindown state, the router blocks all traffic to the interface. However, the
router does not block advertisements as long as VRRP is running on a separate
subinterface. The router changes the state of the subinterface from Admindown
to Up when the state of the partition changes from backup to master.
advertise-mac Enables the subinterface to transmit GARP advertisements when
the partition moves from backup state to master state. By default, GARP
advertisements are blocked on a subinterface.
Grouping ICR Subscribers Based on S-VLAN IDs
Configuring an ICR Partition