Mpls Signaling-Interface - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

mpls signaling-interface

mpls signaling-interface interfaceType interfaceSpecifier
Syntax
no mpls signaling-interface
Command introduced in JUNOSe Release 7.1.0.
Release Information
Specifies a particular layer 2 interface as the signaling interface for an MPLS major
Description
interface that is stacked on an ATM AAL5 interface. MPLS uses the IPv4 or IPv6
interface stacked on the specified interface for signaling. The no version restores the
default behavior, wherein MPLS nondeterministically selects a layer 2 interface as
the signaling interface.
NOTE: You can configure this command only for interfaces that use the interface
label space. For interfaces that use the platform label space, the signaling interface
is always next to the MPLS major interface, that is, stacked on the same lower
interface and is not configurable.
Options
Interface Configuration
Mode
interfaceType Interface type; see Interface Types and Specifiers on page 5
interfaceSpecifier—Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
Chapter 13: M Commands
mpls signaling-interface
1417