Mpls Ldp Targeted-Hello Receive List - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

mpls ldp targeted-hello receive list

[ no ] mpls ldp targeted-hello receive list
Syntax
{ access-list accessListName | ipAddress [ ipAddress ]* }
Command introduced before JUNOSe Release 7.1.0.
Release Information
Configures the list of peer addresses from which MPLS accepts targeted hello
Description
messages. When you configurea receive list, hello messages are accepted only from
list members. If no list is configured, hello messages are accepted from all addresses.
The no version removes the list of peer addresses.
NOTE: This command is unnecessary if you configure the mpls ldp targeted-hello
send list command.
Options
Global Configuration
Mode
accessListName String of up to 32 alphanumeric characters that identifies an
access list
ipAddress IP address of a peer
* Indicates that one or more parameters can be repeated multiple times in a
list in the command line
Chapter 13: M Commands
mpls ldp targeted-hello receive list
1379