Failover-Resync - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

failover-resync

failover-resync { failover-protocol | failover-protocol-fallback-to-silent-failover |
Syntax
silent-failover | disable | not-configured }
no failover-resync
Command introduced in JUNOSe Release 7.3.0.
Release Information
Configures the L2TP peer resynchronization method that an L2TP failed endpoint
Description
uses to resynchronize with its peer non-failed endpoint. This command configures
peer resynchronization for a host profile or a domain map tunnel, and overrides a
global peer resynchronization method that is specified in Global Configuration mode.
The no version restores the default setting, not-configured.
Options
Domain Map Tunnel Configuration, L2TP Destination Profile Host Configuration
Mode
failover-protocol Specifies the L2TP failover protocol method
failover-protocol-fallback-to-silent-failover Specifies the L2TP failover protocol
method; however, if the peer does not support this method, the silent failover
method is used
silent-failover Specifies the silent failover method
disable Disables peer resynchronization
not-configured Specifies that peer resynchronization is not configured for L2TP
host profiles and AAA domain map tunnels. L2TP uses the global failover method;
the default setting
Chapter 7: F Commands
629
failover-resync