Max-Interfaces - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

max-interfaces

For Tunnel Server Configuration mode:
Syntax
max-interfaces { maxInterfacesValue | all-available }
no max-interfaces
For IPSec Tunnel Profile Configuration mode:
max-interfaces maxInterfacesValue
no max-interfaces
Command introduced before JUNOSe Release 7.1.0.
Release Information
IPSec Tunnel Profile Configuration mode added in JUNOSe Release 7.3.0.
For Tunnel Server Configuration mode, provisions the maximum number of
Description
tunnel-service interfaces to be used on a tunnel-server port. The default version
restores the default configuration. On dedicated tunnel-server ports, the default
configuration is all-available (the maximum number of tunnel-service interfaces that
the tunnel-service module supports). On shared tunnel-server ports, the default
configuration is zero tunnel-service interfaces provisioned. The no version
unprovisions the tunnel-server port by reducing the number of provisioned
tunnel-service interfaces to zero.
For IPSec Tunnel Profile Configuration mode, defines the maximum number of
interfaces that the IPSec tunnel profile can instantiate. The no version returns the
maximum value to zero (0) to indicate no limit to the number of interfaces that can
be instantiated on this profile.
Options
IPSec Tunnel Profile Configuration, Tunnel Server Configuration
Mode
1298
max-interfaces
maxInterfacesValue For Tunnel Server configuration, the maximum number of
tunnel-service interfaces that can be provisioned on a tunnel-server port in the
range 0–16000; For IPSec Tunnel Profile configuration, the maximum number
of interfaces that the IPSec tunnel profile can instantiate in the range 0–32767
all-available Specifies that the maximum number of tunnel-service interfaces
that can be provisioned on a tunnel-server port matches the maximum number
supported by the tunnel-server module