Ipv6 Address - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

ipv6 address

[ no ] ipv6 address ipv6Prefix [ eui-64 ]
Syntax
[ no ] ipv6 address [ ipv6Address maskLength [ eui-64 ] ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
Assigns an IPv6 address (or network) to an interface and enables IPv6 processing
Description
on that interface. The no version deletes the association from the interface.
NOTE: The link-local address for an interface is automatically configured when IPv6
is enabled on the interface.
Options
Interface Configuration, Profile Configuration
Mode
1016
ipv6 address
ipv6Prefix Prefix that defines the IPv6 interface or network in the format
ipv6Address / length, where
ipv6Address—Base IPv6 address of the network route that you want to filter
(for example, ::ffff:a:b:c:d)
length Length of the network prefix; number of bits masking base address
to produce address to be matched
ipv6Address—Base IPv6 address of the network route that you want to filter (for
example, ::ffff:a:b:c:d); the ipv6Address must appear in hexadecimal format using
16-bit values between colons. Refer to RFC 2373 IP Version 6 Addressing
Architecture (July 1998) for details.
maskLength Length of the IPv6 mask. A decimal value that indicates how many
of the high-order contiguous bits of the address comprise the prefix (the network
portion of the address).
eui-64 Specifies the use of the eui-64 interface identifier