Mpls Ldp Redistribute - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

mpls ldp redistribute

mpls ldp redistribute protocol [ route-map mapName ]
Syntax
no mpls ldp redistribute protocol [ route-map mapName ]
Command introduced in JUNOSe Release 7.1.0.
Release Information
Enables redistribution of routes from the specified IGP to LDP, enabling LDP to
Description
advertise labeled BGP routes for the inter-AS option C two-stack scenario. The no
version halts redistribution from the specified IGP or according to the specified route
map.
You can specify a route map to redistribute more specific routes to LDP. Only routes
that pass the maps clauses are redistributed. If you do not use a route map for
fine-grained control of route distribution, and you do not want to redistribute BGP
routes, then you do not need to issue this command.
For backward compatibility, if you do not issue this command, LDP continues to
advertise labels for IGP routes including connected, static, IS-IS, OSPF, and RIP
routes, but excluding BGP routes. That is, IGP routes other than BGP are redistributed
to LDP by default.
Options
Global Configuration
Mode
1370
mpls ldp redistribute
protocol Protocol from which routes are redistributed to LDP: BGP, connected,
IS-IS, OSPF, RIP, or static
mapName Name of the route map used to redistribute more specific routing
information from an IGP to LDP