JUNOSe 11.1.x Command Reference Guide A to M
convergence-factor
convergence-factor convergenceFactor
Syntax
no convergence-factor
Command introduced in JUNOSe Release 8.0.0.
Release Information
Specifies the convergence factor for all simple shared shapers on the router. The
Description
convergence factor determines how quickly the dynamic shaping rate converges
with the calculated dynamic shaping rate, and is expressed as a percentage of the
available bandwidth. The no version removes the specified convergence factor from
all simple shared shapers on the router.
Options
QoS Shared Shaper Control Configuration
Mode
Related Topics
464
convergence-factor
convergenceFactor Percentage value in the range 0–99; default value is 50
Configuring Simple Shared Shaper Algorithm Variables