Ip Rip Copy-To-Dynamic - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

ip rip copy-to-dynamic

Syntax
Release Information
Description
Mode
920
[ no ] ip rip copy-to-dynamic
Command introduced before JunosE Release 7.1.0.
Enables RIP on dynamic, unnumbered IP interfaces. You cannot configure RIP on dynamic
interfaces directly. However, this command allows dynamic, unnumbered interfaces
(that refer to numbered IP interface for configuration data) to obtain RIP attributes from
the numbered IP interface to which they refer. The no version disables the feature but
does not remove all existing, active RIP interfaces that were created by this command.
Interface Configuration
Copyright © 2010, Juniper Networks, Inc.