duplex
duplex duplexMode
Syntax
no duplex
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies the duplex mode for an Ethernet interface. This command works with the
Description
speed command; if you set or accept the automatically negotiate setting for either
duplex mode or speed, the router negotiates both parameters with the remote device.
The no version specifies the default value, automatically negotiate or full duplex (FE-8
SFP I/O module only). This command is not available for the Ethernet interface on
the SRP module.
Options
Interface Configuration
Mode
duplexMode One of the following duplex options
automatically negotiate Specifies that the router negotiates duplex mode
with the remote device; not valid for the FE-8 SFP I/O module
full Specifies that the router uses full duplex on a Fast Ethernet or Gigabit
Ethernet interface
half Specifies that the router uses half duplex on a Fast Ethernet interface;
this value is not valid for Gigabit Ethernet interfaces
Chapter 5: D Commands
553
duplex