Frame-Relay Keepalive - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

frame-relay keepalive

frame-relay keepalive [ seconds ]
Syntax
no frame-relay keepalive
Command introduced before JUNOSe Release 7.1.0.
Release Information
Enables the LMI mechanism for serial lines using Frame Relay encapsulation. The
Description
no version disables this capability. The keepalive command is similar to the
frame-relay lmi-t391dte command.
Options
Interface Configuration
Mode
seconds—Number in the range 5–30; default value is 10 seconds; defines the
keepalive interval; the interval must be set, and the value on the DTE should be
less than the value set on the DCE
Chapter 7: F Commands
647
frame-relay keepalive