Default-Information Originate - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

default-information originate

For BGP:
Syntax
default-information originate [ route-map mapTag ]
no default-information originate [ route-map [ mapTag ] ]
For IS-IS:
[ no ] default-information originate [ route-map mapTag ]
For RIP:
[ no ] default-information originate [ route-map mapTag ]
default-information originate always
For OSPF:
[ no ] default-information originate [ always | metric metricValue | metric-type 1 |
metric-type 2 | route-map mapTag ]*
Command introduced before JUNOSe Release 7.1.0.
Release Information
Enables BGP to advertise a default route (0.0.0.0/0) if the default route exists in the
Description
IP routing table. If the default route does not exist, you must configure it using the
ip route command.
When you issue this command in the route-target address family, BGP advertises
the Default-RT-MEM-NLRI route (0:0:0/0)
For IS-IS, OSPF, and RIP, configures a default route for the distribution of default
information into the respective routing domain. IS-IS creates the default route
(0.0.0.0/0) if it does not exist in the IP routing table. OSPF and RIP do not create the
default route unless you use the always option.
For all protocols, the no version disables advertisement of the default route. The
syntax varies with the protocol.
Options
mapTag Name of route map used to import the default route; string of up to
32 characters
always Creates the default route, so that it is always advertised
metricValue Sets the metric for the default route; in the range 0–4294967295
metric-type 1 Sets the default route's metric type to OSPF external type 1
Chapter 5: D Commands
default-information originate
501