L2Tp Unlock-Test Destination - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

l2tp unlock-test destination

l2tp unlock-test destination { destinationName |
Syntax
[ virtual-router vrName ] ip ipAddress }
Command introduced in JUNOSe Release 7.2.0.
Release Information
Forces L2TP to disregard any remaining lockout time and immediately begin the
Description
lockout test procedure for the specified destination. If lockout testing is not enabled,
this command immediately unlocks the destination. There is no no version.
Options
Privileged Exec (at privilege level 10 or higher)
Mode
1198
l2tp unlock-test destination
destinationName Name of the L2TP destination
vrName Name of the virtual router on which the destination exists
ipAddress IP address of the destination