Debounce-Interval - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

debounce-interval

debounce-interval seconds
Syntax
no debounce-interval
Command introduced in JUNOSe Release 9.3.0.
Release Information
Modifies the minimum time an Ethernet interface must maintain a given state for
Description
example, up or down before the interface notifies the upper-layer protocols of the
state change. The no version restores the default value, 1 second.
NOTE: You can configure this command only if you have enabled the debounce timer
feature using the debounce command.
Options
Interface Configuration
Mode
480
debounce-interval
seconds Interval for which an interface must maintain a given state before the
interface reports the state change to the upper-layer protocols. Number in the
range 1–5 seconds; default value is 1 second.