Ip Rip - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

ip rip

[ no ] ip rip
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
Configures RIP to run on the network specified by the network command. Uses the
Description
default values: send version is RIP version 1, receive version is RIP version 1 and
version 2, authentication is not enabled. The no version deletes the RIP interface.
Interface Configuration, Subinterface Configuration
Mode
922
ip rip