Debug Ip Pim - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

debug ip pim

The syntax differs for PIM Dense Mode and PIM Sparse Mode.
Syntax
PIM Dense Mode:
debug ip pim { pimLog [ severity { severityValue | severityNumber } ]
[ verbosity verbosityLevel ] | switchState groupAddress sourceAddress |
dense-mode { on | off } }
PIM Sparse Mode:
debug ip pim { pimLog [ severity { severityValue | severityNumber } ]
[ verbosity verbosityLevel ] | switchState groupAddress sourceAddress |
sparse-mode { on | off | sg-state [ group groupAddress
[ source sourceAddress ] | rp rpAddress ] [ count ] } }
no debug ip pim pimLog
Command introduced before JUNOSe Release 7.1.0.
Release Information
Shows information about the selected variable. The no version disables the display.
Description
Options
488
debug ip pim
pimLog PIM log of interest; one of the following options:
autoRp-rcvd Auto-RP packets received
autoRP-sent Auto-RP packets sent
engineering PIM engineering
hellos-rcvd PIM hello messages received
hellos-sent PIM hello messages sent
packets PIM packets received and sent
packets-rcvd PIM packets received
packets-sent PIM packets sent
severity Specifies the minimum severity of the log messages displayed for the
selected category; described either by a descriptive term severityValue or by
a corresponding number severityNumber in the range 0–7; the lower the
number, the higher the priority:
emergency or 0 System unusable
alert or 1 Immediate action needed
critical or 2 Critical condition exists
error or 3 Error condition