Mpls Ldp Session Keepalive Interval - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

mpls ldp session keepalive interval

mpls ldp session keepalive interval seconds
Syntax
no mpls ldp session keepalive interval
Command introduced in JUNOSe Release 8.1.0.
Release Information
Sets the transmission interval at which LDP sends session keepalive messages to
Description
maintain the LDP session. Keepalive messages are sent to LDP peers at this interval
in the absence of any other LDP traffic over the session. This command takes effect
immediately. The no version restores the default interval, 20 seconds.
Options
Global Configuration
Mode
1372
mpls ldp session keepalive interval
seconds Number of seconds, in the range 1–65535