Ethernet Oam Lfm Pdu-Transmit-Interval - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

ethernet oam lfm pdu-transmit-interval

[ no ] ethernet oam lfm pdu-transmit-interval period [ mode { active | passive } |
Syntax
pdu-lost-threshold pduLostPackets ]
Command introduced in JUNOSe Release 11.1.0.
Release Information
Configures the minimum rate at which OAM protocol data units (PDUs) are
Description
transmitted in milliseconds. Also, specifies the discovery mode of the OAM client
and the number of OAM packet data units (PDUs) from the remote peer that an
interface on the local client can miss before the link between the two entities is
considered down. The no version removes the frequency values configured on the
interface for transmission of OAM PDUs to the remote peer. The no version with the
mode keyword deactivates link-fault management on the interface.
Options
Interface Configuration
Mode
Related Topics
period Interval at which OAM PDUs are sent from the local OAM entity to the
remote peer to maintain the OAM association in an active state. Number in the
range 100-1000 milliseconds; default value is 1000 milliseconds
mode Configures the OAM client mode for the discovery process
active Sets the discovery mode of the local OAM client as active. In active mode,
the interface discovers and monitors the peer on the link if the peer also supports
IEEE 802.3ah OAM functionality. This is the default discovery mode of the OAM
client
passive Sets the discovery mode of the local OAM client as passive. In passive
mode, an OAM entity does not initiate the discovery process. You cannot perform
link-fault management if you configure both the local client and the remote peer
for passive mode operation
pduLostPackets The window for which the local client waits to receive OAM
packets from the remote peer before it generates a link fault event. Number of
expected OAM packets from the remote peer that the local OAM client can miss
before a link-fault event is triggered; a number in the range 3–10; default value
is 5
OAM Discovery Feature
Configuring 802.3ah OAM Link-Fault Management
ethernet oam lfm mode on page 589
Chapter 6: E Commands
ethernet oam lfm pdu-transmit-interval
591