L2Tp Failover-Resync - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

l2tp failover-resync

l2tp failover-resync { failover-protocol | failover-protocol-fallback-to-silent-failover |
Syntax
silent-failover | disable }
no l2tp failover-resync
Command introduced in JUNOSe Release 7.3.0.
Release Information
Configures the global L2TP peer resynchronization method that an L2TP failed
Description
endpoint uses to resynchronize with its peer non-failed endpoint. This setting can
be overridden by a peer resynchronization method that is configured by either an
L2TP host profile or an AAA domain map tunnel configuration. The no version disables
peer resynchronization. The default version restores the default peer
resynchronization method, failover-protocol-fallback-to-silent-failover.
Options
Global Configuration
Mode
1176
l2tp failover-resync
failover-protocol Specifies the L2TP failover protocol method
failover-protocol-fallback-to-silent-failover Specifies the L2TP failover protocol
method; however, if the peer does not support this method, the silent failover
method is used; this is the default setting
silent-failover Specifies the silent failover method
disable Disables peer resynchronization