Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual page 972

JUNOSe 11.1.x Command Reference Guide A to M
Global Configuration, VRF Configuration
Mode
930
ip route
last-resort Installs the static route in the routing table even if the specified RTR
operation is currently unreachable, provided that no other static route to the
same network prefix is available
verify bfd-liveness-detection Installs the static route in the routing table only if
the next hop to the specified destination address is verifiable by means of BFD
liveness detection
minInterval Minimum proposed transmit interval and required receive interval
for BFD control packets; has the same effect as configuring the minimum receive
interval and the minimum transmit interval to the same value; number in the
range 100–65535 milliseconds for ES2 4G LM only, the range is 10–65535
milliseconds; default value is 300 milliseconds
minRecInterval Minimum interval at which the local peer must receive BFD
control packets sent by the remote peer; number in the range 100–65535
milliseconds for ES2 4G LM only, the range is 10–65535 milliseconds; default
value is 300 milliseconds
minTransInterval Minimum proposed interval between BFD control packets
sent by the local peer; number in the range 100–65535 milliseconds for ES2
4G LM only, the range is 10–65535 milliseconds; default value is 300 milliseconds
multValue Detection multiplier value that the remote peer router multiplies by
the local peer's negotiated transmit interval to determine the remote peer's BFD
liveness detection interval; equal to the number of BFD packets that can be
missed before the BFD session is declared down; number in the range 1–255;
default value is 3