Mpls Traffic-Eng Flood Thresholds - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

mpls traffic-eng flood thresholds

mpls traffic-eng flood thresholds { up | down } percentage [ percentage ]*
Syntax
no mpls traffic-eng flood thresholds { up | down }
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies thresholds for the flooding of the current reservable bandwidth throughout
Description
the network. You can configure a set of thresholds for increases or decreases in
bandwidth. Flooding is triggered when the reservable bandwidth increases past any
up threshold or decreases past any down threshold. The no version restores the
following default values:
Options
Interface Configuration, Subinterface Configuration
Mode
1430
mpls traffic-eng flood thresholds
For increases in bandwidth (up changes) 15, 30, 45, 60, 75, 80, 85, 90, 95, 97,
98, 99, 100
For decreases in bandwidth (down changes) 100, 99, 98, 97, 96, 95, 90, 85,
80, 75, 60, 45, 30, 15
up Specifies that an increase in bandwidth past the threshold triggers flooding
down Specifies that a decrease in bandwidth past the threshold triggers flooding
percentage Percentage of reservable bandwidth, a value from 1 to 100 percent
for increasing bandwidth and from 0 to 99 percent for decreasing bandwidth
* Indicates that the percentage can be repeated multiple times in a list in the
command line